User Guide

20
CALCULATED VALUES
CO
2
Measuring Range (Fuel-Dependent) 0 - CO
2
max
Abs.Accuracy ± 0.3 Vol. %
Lambda (Air/Fuel Ratio)
Measuring Range Jan 20
Excess Air
Measuring Range 0 – 999%
Poison Index
Measuring Range 0.0001 - 10.0
Flue Gas Loss qA
Measuring range 0 – 99.9%
Efficiency
Measuring Range 0 – 120%
Readings Can Be Shown In
mg/Nm
3
O
2
Ref
mg/kWh
NOx: mg/Nm3 NO
2
11.3 UPDATING THE FIRMWARE
• Turn on the BluFlame.
• Select the following: ➡Extras ➡
Device info ➡The third line will show, e.g.:
Firmware version 0.99.30
If you run into any problems during the update,
we will need you to provide certain information.
Write down your firmware version here ______________________
Write down your serial number here ______________________
11.3.1 CARRYING OUT AND CHECKING THE
UPDATE
Preparing a micro SD card
If you did not receive the new firmware on a micro SD card, e.g., if you
received it by e-mail instead, you must first copy the “1107.fwb” file to the SD
card’s root directory (i.e., not to a subfolder).
If you received this file packed in a ZIP file, you will need to unzip it before
copying it.
Carrying out the update
The BluFlame must have at least 60% of its battery charge
remaining before an update can be applied.
• Copy file 1107.fwb to the SD card (to the root directory, i.e., not to a folder).
• Insert the micro SD card into the BluFlame’s card slot and turn on the BluFlame.
The SD card contacts must be facing upwards when the card is
inserted into the SD card slot, and the SD card must lock into place
inside the BluFlame. To remove the SD card, lightly push it into the BluFlame
in order to release the card lock.
• Wait until a message saying “New firmware... found” appears.
• Select “Install firmware” and confirm.
➡The update mechanism will start.
• Wait about 45 seconds. Do not press any buttons during this time.
• After the update, turn on the BluFlame with the Power icon.
• Confirm the “Firmware update completed...” prompt with OK.
✔ The update has been successfully completed.
How can I check if the update was successful?
• Turn on the BluFlame.
• Select the following: ➡Extras ➡Device info
✔ The firmware version will be shown.
What can I do if the old firmware version is still being shown?
Repeat the update procedure.
Where can I get help if the update was not successful?
Contact your outside sales representative or e-mail: [e-mail]