User Guide

DS-220R User’s Guide
11
Turning Tank Capacity Mode Off
Perform the following steps to turn the Tank Capacity Mode Off:
1. While holding down, press . The SET TANK indicator will turn on, and
ON will show on the display. This indicates that the Tank Capacity Mode is
currently on.
2. Turn the Tank Capacity Mode off by pressing . The display will show OFF,
and the Alternate Numeric Display will turn off.
3. Press to return to normal operation.
Turning the Tank Capacity Mode On without Re-training
The Tank Capacity Mode can be turned back on without retraining. The DS-220R will
remember the previous 0% and 100% set points until the unit is re-trained as above. To
turn the Tank Capacity Mode on without re-training, perform the following steps:
1. While holding down, press . The SET TANK indicator will turn on, and OFF will
show on the display. This indicates that the Tank Capacity Mode is currently off.
2. Turn the Tank Capacity Mode on by pressing . The display will show ON, and the
Alternate Numeric Display and Percent Indicator will turn on.
3. Press to return to normal operation.
Battery Level Indicator
The battery level indicator shows the relative strength of the batteries. Full power is
indicated by four bars. As the batteries are depleted, the number of bars displayed
decreases, until no bars are left. At this point, it is necessary to replace the batteries (refer
to the Battery Installation section above). If the battery power drops to the point where the
DS-220R can no longer function accurately, the alarm will beep 20 times and the power will
turn off automatically. When the batteries are replaced, and the scale is turned back on, the
DS-220R will resume operation with all previous setting intact.