User Guide

DS-220 User’s Guide
5
Quick Start
To operate the DS-220 as a basic weigh scale, perform the following steps:
Setup
1. Unpack the scale as described in the “Unpacking the DS-220” section below.
2. Install the batteries into the control box as described in the “Battery Installation” section
below.
3. Place the Weighing Platform on a firm, level surface.
4. Turn the DS-220 on by pressing .
5. If desired, turn on the backlight by momentarily pressing .
6. Select the weigh mode by repeatedly pressing . The mode indicators will cycle as
follows:
WEIGHT è VOLUME è VOLUME SPECIFIC GRAVITY è COUNT.
7. In Weight or Volume mode, select the proper measurement units by repeated pressing .
The units will cycle as follows for each corresponding mode:
WEIGHT:
kilograms è pounds è pounds and ounces è ounces
VOLUME (and VOLUME SPECIFIC GRAVITY):
liters è gallons è fluid ounces
8. In Weight or Volume mode, select the desired display resolution by repeatedly pressing
as described in the RESOLUTION section.
9. If in Volume Specific Gravity Mode, adjust the Specific Gravity as described in the
MEASURING VOLUME section.
10. If in Count mode, train the scale as described in the COUNTING section.