User Manual
Table Of Contents
- Notice
- About This Guide
- Guide to Conventions
- Trademarks
- Table of content
- Table of Figures
- 1. Introducing ExaSAN PCIe2.0 Storage Systems
- 2. Preparing to Install ExaSAN B08S2-PS
- 3. Installing the ExaSAN B08S2-PS
- 4. Using RAIDGuardX GUI
- 4.1 Accessing the RAIDGuardX GUI
- 4.1.1 RAIDGuard X Client and Server
- 4.1.2 RAIDGuard X Menu Bar
- 4.1.3 Updating the ExaSAN RAID system Firmware
- 4.1 Accessing the RAIDGuardX GUI
- 5. RAID Overview
- 6. Appendices
4. How to Use
User Guide Page 4-1
4. Using RAIDGuardX GUI
After you have connected all your ExaSAN components, powered the system on, and installed the
RAIDGuardX drivers, we will first need to perform some basic configuration and setup before the
ExaSAN RAID system is fully operational.
Figure 33: GUI “Main screen”
Function Description
1
Add Controller Add RAID controller/system to RAIDGuard X
Remove Controller Remove RAID controller/system from RAIDGuard X
2
Create Array
Create an array from disk drives in the storage system
Delete Array Delete an array in the storage system
3 Email Set email notification
4 Preference
Drive Lag Proof Enable/ Disable Drive Lag Proof
NCQ Mode
Enable/ Disable NCQ mode
SMART Mode Enable/ Disable SMART Mode
Beeper Enable/ Disable Beeper
Equalization Enable/ Disable Equalization