User Manual
Table Of Contents
- Notice
- About This Guide
- Guide to Conventions
- Trademarks
- Table of content
- Table of Figures
- 1. Introducing ExaSAN PCIe2.0 Storage Systems
- 2. Preparing to Install ExaSAN B08S2-PS
- 3. Installing the ExaSAN B08S2-PS
- 4. Using RAIDGuardX GUI
- 4.1 Accessing the RAIDGuardX GUI
- 4.1.1 RAIDGuard X Client and Server
- 4.1.2 RAIDGuard X Menu Bar
- 4.1.3 Updating the ExaSAN RAID system Firmware
- 4.1 Accessing the RAIDGuardX GUI
- 5. RAID Overview
- 6. Appendices
3. Installation
User Guide Page 3-17
Figure 30: more info About this MAC
Under the Hardware category, click on PCI Cards to bring up information on PCI cards that are
installed in the system. If the driver has been correctly installed, the HBA is listed with the Accusys6xxxx
identifier (actual name may vary) as a RAID Controller. If you do not see the HBA listed here, power
off the host server, reseat the card, and reinstall the driver. Refer to Appendix A FAQ Q7if the problem
persists.
Figure 31: MAC Pro info
3.3.5.2 Confirming the ExaSAN RAID system driver in Windows
After installing the ExaSAN RAID system HBA driver on a Windows based host server, confirm the
driver has been properly installed.