User`s manual

Accurate Technology ProScale Page 28 of 48
To enter PROGRAMMING MODE, press and hold the MODE key and then
momentarily press the 0 (zero) key. The MODE key must be held for
approximately 1 second before the depression of the 0 (zero) key.
Once you are in the Programming Mode, momentarily pressing the MODE
key will advance through the Programming Parameter list.
To step backwards in the Programming Parameter list press and hold the
ON/OFF key and momentarily press the MODE key.
Momentarily pressing the + (plus) key while displaying a Programming
Parameter will increase the parameter setting.
Momentarily pressing the - (minus) key while displaying a Programming
Parameter will decrease the parameter setting.
Momentarily pressing the 0 (zero) key while displaying a Programming
Parameter will revert the parameter to its factory default setting.
CAUTION: The Limit Mode (See Programming Parameters 14,15,16,17)
functionality is still active even while the Display is in PROGRAMMING MODE.
Changing LIMITS may result in the Limit/Monitor Signal hardware output
becoming active immediately.
To exit PROGRAMMING MODE, press and hold the MODE key and then
momentarily press the 0 (zero) key.
NOTE: The Display will automatically exit PROGRAMMING MODE after 60
seconds of no key activity.
Programming Parameters
Programming Parameters are listed below. Values in [ ] are the available
range of values that can be programmed for that entry. Factory defaults are
shown in Red.
Some Programming parameters, Offset Addition and Limit mode, indicate a
‘factory default set in inches’. The equivalent offset/limit value in mm or cm
is applied if you switch the measurement MODE of the Display to mm or cm.
(ie. If 5.00(in) is set, when the Display is switched to mm the programmed
offset/limit is now 127mm.)