Instruction manual

Programmable (Including Externally Powered Displays)

Display Programming

This display must be programmed for the user's preferences before use.

All display programming is done through the keypad on the display face.

All programming parameters are saved in memory and are preserved in

the event of power failure. To enter programming, press and hold the

MODE key, then press the ZERO key. The display will show the

following:

Note: If no change occurs to the display, the display programming

option has been disabled. To enable the programming options,

JP1 inside the display must be set to the B position.

The left-most digit represents the programming option (1 to 9). Each of

these options represents a different program parameter. The number on

the right represents the current value of the parameter. To change the

parameter value, press the PLUS/MINUS key to increase/decrease the

displayed value. (Each parameter has a limited range and cannot be

exceeded by additional presses of the PLUS or MINUS key).

To move to the next programming parameter, momentarily press the

MODE key. The programming parameter (left side) will increase by one,

1 0