Instruction manual

40
1/4 DIN Panel Mount Displays
Power Supply
There are two versions of the 1/4 DIN Panel mounted displays. The first
version requires power supplied from two "D" cell batteries (shipped with
the display). The second version requires the installer to hook up power
(24 volts, AC or DC) to the display.
Mounting the Display
A cutout must be made in the panel where the display is to be mounted.
The cutout should measure at least 90mm x 90mm (3.6 x 3.6 inches).
The cutout should measure no larger than 93mm x 93mm (3.7 x 3.7
inches).
The casing of the panel mount displays "sandwich" a panel between the
front cover and the rear cover. The displays are designed to
accommodate any panel thickness between 0.125" and 0.750".
Note: For any panel thinner than 0.125 inches, shorter screws
must be used for the display casing. If shorter screws are not used,
damage to the front cover will occur.