Instruction manual

36
Standard and SPC Displays
Changing the Measurement Readout:
Press the MODE key (while in ABS mode) to change the measurement
readout. The current measurement readout is saved when power is off.
Readouts appear in the following order:
1. mm.
2. Decimal inches.
3. 16ths of an inch, each bar in the display's upper right corner
represents an additional 1/64
th
of an inch.
4. 32nds of an inch, each bar in the display's upper right corner
represents an additional 1/64
th
of an inch.
5. 64ths of an inch.
Setting ABS Position
When the display is in ABS mode (indicated by ABS in the upper left
corner of the display), a zero point is established by pressing the ZERO
key. All subsequent absolute measurements will reflect distance from
this point. The display should be locked to prevent accidental resetting.