Instruction manual

33
Basic and Incremental Displays
Changing the Measurement Readout:
Press the MODE key to change the measurement readout. The current
measurement readout is saved when power is off. Readouts appear in
the following order:
1. mm.
2. Decimal inches.
3. 16ths of an inch, each bar in the display's upper right corner
represents an additional 1/64
th
of an inch.
4. 32nds of an inch, each bar in the display's upper right corner
represents an additional 1/64
th
of an inch.
5. 64ths of an inch.
Setting Zero
A zero point is easily established by pressing the ZERO key when the
display is unlocked. All subsequent measurements will reflect distance
from this point.
The positions of the internal jumpers may be changed to limit the
available display options or change the resolution. See the display
options charts starting on page 48 for more information.