Instruction manual

ProPanel

ProPanel is a portable measuring system capable of edge-to-edge,

edge-to-hole, hole-to-hole, and corner-to-corner measurements up to

1.2m (48in.).

ProPanel is easy to use. By following the instructions in this section,

reliable, error-free operation is assured.

Assembly:

ProPanel is assembled at the factory. If using the ProPanel to measure

hole-to-edge or hole-to-hole distances, install the provided cones using

the enclosed hex wrench.

Operation:

Edge-To-Edge Measuring:

Use ProPanel like a T-square. Close the jaws, and take the

measurement.

Note: Do not use the outer edges of the jaws for measurements. If

possible, use the full width of the jaw for reliable measurements.

Corner-To-Corner Measuring:

Place the ProPanel jaws over the panel corners. Gently "wiggle" the

ProPanel while applying light closing pressure to seat the corners.

Change to Incremental mode by pressing the red button on the display.

(Press the zero key to zero the display if necessary.) Measure the

second diagonal. The difference in diagonal lengths will be shown on

the display. If the diagonal measurements are equal and any two

adjacent edges are equal, then the panel is square. Press and hold the

red button on the display for three seconds to return to Absolute mode.