Instruction manual

21
ProStop
ProStop is a complete digital stop and fence system for chop saws,
radial arm saws, and miter saws.
ProStop is easy to install. By following the basics of good installation in
this section, reliable, error-free operation is assured. Because ProStop
can be installed on so many different types and brands of equipment, all
installations will be different. Therefore, it's the responsibility of the
installer to choose the bolts, screws, or other mounting hardware that
guarantee proper installation for optimum operation.
Assembly:
Each ProStop shipped from Accurate Technology will have at least two
packages. The first contains the linear scale and fence extrusion. The
second package contains the digital stop, an anti-tearout block, and
mounting hardware. These parts should be assembled prior to mounting
the ProStop.
1. Readhead installation: Note the readhead’s sensitive internal ground
fingers. Carefully slide the readhead onto the scale (see diagram on
next page).
2. Stop Installation: Loosen the locking knob and slide the stop into the
fence extrusion.
3. Slide the readhead up to the stop and slip the guide clip over the
post on the readhead.
4. Display Installation: The display should be mounted to the aluminum
block on the stop using the enclosed Velcro. Plug the readhead into
the display.
5. Next, move the stop assembly left to right and note if the ProStop
readings increase or decrease. Depending upon the installation (left