Instruction manual

The Display should be mounted in a location which allows for easy

viewing by the machine operator. The location of the parts should

also safeguard the cable from possible damage. All ProScale wiring

should be kept as far away as possible from the machine’s wiring

and motors and dust collection systems. Avoid running the

readhead wiring parallel to high voltage/current wiring.

3. Mount the readhead using three screws or bolts. It may be

necessary to use washers or spacers to ensure a good mount (if the

readhead is to be mounted on an uneven surface).

4. Check that the scale is properly aligned with the direction of motion

of the moving part. The connector link will compensate for only a

small amount of misalignment. The connector link must be mounted

in the same direction as the scale (as in the figure below).

Note: Failure to use the connector link will void the warranty.

5. Mount one end of the connector link to the scale using an M5 (or 10-

32) screw and the other end to the moving part of the machine.

Check that both connections are very secure; inaccurate/erratic

readings may otherwise occur.

6. Plug the readhead into the display. See Section 3 regarding

mounting and use of different display versions.

MOVING PART OF MACHINE

DISPLAY

CONNECTOR LINK

MOVEMENT

A Typical Model 150 Installation

READHEAD