Installation manual

Operation Manual for LCD Digital Readouts Page 40 of 48
Pr 11 – Displayed Measurement Units [0 to 6, 0]
This parameter controls the type of measuring units that will be displayed on
the DRO.
The table below illustrates the possible combinations of measuring units that
can be configured by changing the value of this programming parameter.
Default = 0
Pr 12 – Auto-Off Time [0 to 240, 15]
This parameter allows changing of the amount of time before the display turns
off to conserve battery power. The value of this parameter represents the
number of minutes of idle operation (no movement or key presses) before the
display turns off.
When Auto off is enabled, pressing the ON/OFF key or movement of the encoder
will wake up the DRO.
A value of ‘0’ disables the auto off feature (DRO is always ON).
Default= 15
Pr 13 – Linear Compensation [0.00001 to 9.99999, 1.00000]
This parameter sets a linear multiplier correction factor in the DRO that is
applied to the actual measurement prior to any offsets and then the adjusted
measurement is displayed on the LCD. This is useful, for instance, if you would
like to display half, double, or any other value that can be achieved by
multiplying the amount of actual movement by the value of the parameter
setting.
Default = 1.00000
Pr 14 – ProScale Compatibility [0 or 1]
This enables or disables compatibility with long ProScale ABS systems.
Disable [set to 0] for all ProScale 150-10, 180, 280, 380 and 580 systems.
Enabled [set to 1] for ProScale Model ABS systems longer than 16 inches
(Model 150-18 and all Model 250 systems).
Default = 1
Pr 11 Parameter Setting Displayable Units
0
All inch units, metric in millimeters
1
Millimeters only
2
Decimal inches and millimeters
3
Decimal inches and centimeters
4
All inch units, metric in centimeters
5
Centimeters only
6
Decimal inches only