User manual

Accurate Technology Digi Fence Page 15 of 16
Frequently Asked Questions
What F/W (Firmware) version do I have?
The display will show d 2.xxx on power up. This is the firmware version of your
Readout.
What does “no Enc” mean?
If the Encoder cable is unplugged from the Readout, no Enc will appear on the display.
To clear: Be sure the Encoder is on the scale and plugged into the readout
The keys don’t seem to do what they are supposed to do.
Timing, that is how long a key is depressed, and the combination of the keys pressed is
important. This manual uses the term ‘”momentarily” to describe a key press of
typically less than 1 second. Whereas “press and hold” is used imply a key press of
typically longer than 1.5 seconds. As an example; when using a PC keyboard to type a
capital letter you would “press and hold” the SHIFT key and “momentarily” depress the
LETTER key.
In addition, keep in mind the key’s “function” is executed on the key RELEASE, not the
key DEPRESS. This is important since some keys execute different functions based
on how long they are depressed.
The battery clips seem to be very loose. Is this normal?
Yes. DO NOT attempt to bend these clips or wedge anything between them and the
case. These clips are designed to expand when the two case halves are screwed
together.
The readings are “backwards”?
You can change the “scaling” direction of the system by:
1. Reversing the orientation of the Encoder on the Scale.
2. Changing the value of Programming Parameter Pr 2.