User manual

Accurate Technology Digi Fence Page 14 of 16
Programming Parameters
Programming Parameters are listed below. Values in [ ] are the available range of
values that can be programmed for that parameter.
Factory defaults are shown in Bold Red.
Pr 1: 0 Key Value [0 to + 999.999in] or [0 to +9999.99mm]
The programmed value that will be recalled whenever the 0 (zero) key is pressed during
normal operation.
Default = 0
Pr 2: Reverse Scaling [0 or 1]
This parameter controls the sign of travel (positive vs negative) when the measuring
system is moved.
Default = 0
Pr 3: Key Lockout [0 or 1]
This parameter controls the operation of the +, - and 0 keys. If enabled (set to 1), these
keys will not function and the word LOCK will appear on the display. This prevents
accidental changes when depressing these keys during normal operation.
Default = 0
Pr 4: Display Resolution [1, 2 or 3]
This parameter sets the number of places to the right of the decimal point on the
display when the Digi Readout is in a decimal mode (in or mm).
A value of 1 will display x.x.
A value of 2 will display x.xx
A value of 3 will display x.xxx
Default = 2
NOTES:
Decimal inches have a maximum of 3 places.
Millimeters have a maximum of 2 places (even if parameter is set to 3.)
This setting has no effect when displaying fractions.