User manual

DigiScale Manual Part # 800-1404-001 Page 30 of 36
DATUM KEY
The DATUM key is used to change the currently displayed value.
Momentarily pressing the DATUM key forces the readout to a user
programmed value. This can be zero or any other displayable value.
See Section 4: Programming, Programming Parameter Pr1
The DATUM key can also be locked out to prevent accidental entries.
See Section 4: Circuit Board Jumpers, JP 2
Additional functions of the DATUM key:
Press and hold DATUM for 7 seconds to display the firmware version.
Press and hold DATUM for 9 seconds to enter programming mode.
Press and hold DATUM for 3 seconds to exit programming mode.
Momentarily press
Press & Hold