Specifications

DigiPump

DigiPump DigiPump

DigiPump SR7x

SR7xSR7x

SR7x Sy

Sy Sy

Syringe Pump

ringe Pump ringe Pump

ringe Pump Operator

OperatorOperator

Operator’s

s Manual

Manual Manual

Manual

Note: The accumulated volume can be viewed during the infusion pressing the SELECT key,

but to clear the accumulated volume the syringe pump need to be in STOP mode.

Note: accumulated volume can be cleared only in STOP condition.

Step 7 Start infusion

(1) After all values are set and the syringe is properly installed, press START key to start the

infusion, the infusion lights will flash from right to left. The piston shall drive the syringe

from right to left slowly as the infusion begins.

Note: The faster the infusion lights flash, the higher the infusion rate is.

Step 8 Infusion completion

As shown in the figure bellow, when the infusion comes close to near completion, the NEAR

indicator light is ON, accompanied with an audible alarm signal to alert the user.

Note: The NEAR alarm can be silenced by pressing the adjusting knob. The NEAR audible

alarm will sound again in 2 minutes.