Safety data sheet

Material Safety Data Sheet Page 5 of 8
Report No.: DGC160223010GE
This document cannot be reproduced except in full, without prior written approval of ATC. Any unauthorized alteration, forgery or falsification of the content or appearance of
this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the
sample(s) tested and such sample(s) are retained for 30 days only.
Accurate Technology Co., Ltd.
Address: No.345, Baima Block, Guantai Road, Nancheng District, Dongguan, Guangdong, China
Tel: [phone] Fax: [phone] Email: [e-mail] Http://www.dgatc-lab.com
Section 7 - Handling and Storage
Handling Precautions: 1. With closed operation, provide a good natural ventilation. The operator
must go through specialized training, strict compliance with operating rules. 2. Keep away from heat,
ignition sources and no smoking. Use non-sparking ventilation explosion-proof type equipment. 3. Do
not crush, short (+) and (-) battery terminals with conductive (i.e. metal) goods. 4.Do not directly heat or
solder. Do not throw into fire or the place where may be submerged by water. 5. Do not be installed in
sealed equipments. 6. Make sure than the connection between batteries is correct. 7. Do not use the
battery in places where are full of dust (it should be regular checked when used in dusty environment). 8.
Use tools which are with insulating bush when handling. 9. Do not clean the battery with diluent,
gasoline, kerosene or composite liquid. 10. Slow handling when disassembly. 11. Do not cover the
battery with materials which can produce static electricity. 12. Battery do not be thrown away, put in as
much as possible separated from other garbage. 13. Pay special attention to be not smash foot.
Storage Precautions: 1. Stored in a cool, dry, well-ventilated place, keep batteries in non-conductive
(i.e. plastic) trays. Storage areas should be clearly marked "no obstacles." 2. Away from combustibles
areas. Away from heat, ignition sources. Avoid overheating and supercooling. Avoid contacting with
metal containers directly, adopt acid proofing and flame resistant materials. 3. Near the storage areas
have adequate fire extinguishers and spill clean-up equipment. 4. Avoid storing large quantities of
indoor, as much as possible stored in the isolation of the fire building. 5.Small parts, avoid contact with
children, to avoid being swallowed children.
Section 8 - Exposure Controls, Personal Protection
Engineering controls: Keep good conditions for natural ventilation.
Personal Protective Equipment:
During installation, normal conditions of use or in the event of battery breakage, no exposure to lead and
lead containing battery paste. Exposure to sulphuric acid and acid mist might occur during charge.
Respiratory protection: Not necessary under normal use. In case of battery rupture, use self-contained
full-face respiratory equipment, equipment with type ABEK filter.
Eye protection: Processing of this product releases vapors or fumes which may cause eye irritation.
Where eye contact may be likely wear chemical goggles and have eye flushing equipment available.
Hand protection: Use insulated rubber gloves
Body protection: Wear acid resistant apron or clothes