Instruction Guide

DETAIL A

DETAIL B

1) Remove Door from Chassis by removing

Top and Bottom Hinges. Keep screws,

discard hinges.

2) Attach customer supplied handle to Door Panel

using countersunk screws.

3) Screw Door Panel to Frame.

4) Slide Frame over Refrigerator door and attach

with 1 screw on each side, center of door.

5) Screw Bottom Pc to Door.

6) Attach Top Brace to Frame with 1 screw on side.

Attach Bottom Brace in the same manner.

7) Drill a hole thru the Top and Bottom Frame using

the Braces as a guide with a 5/32" drill bit. Install

screws to finish attaching the Top and Bottom

Braces securely to the Frame.

8) Drill a hole into the Door Panel from the top and

bottom using the Braces as a guide with a 1/4"

drill bit. Do not exceed 5/8". This is the hole that

the door will pivot on.

9) Remount the door using the supplied Top and

Bottom Hinges.

Top Hinge

Bottom Brace

Frame

Bottom

Step 7

Step 8

Top Brace

Instructions for

Integrated Frame

Summit Appliance

1-718-893-3900

(Built-In Application)

Door Panel

Hinge