COMPACT REFRIGERATOR-FREEZER Model: FF711ES User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Felix Storch, Inc. An ISO 9001:2015 registered company 770 Garrison Ave Bronx, New York 10474 www.summitappliance.
TABLE OF CONTENTS Important Safeguards 3-4 Location of Parts 5 Installing your Refrigerator 6 Test Run 6 Reversing the Door Swing 7-8 Temperature Control 8 Removing Ice Cubes from the Tray 9 Cleaning and Care 9 Troubleshooting 10 Limited Warranty 12 2
IMPORTANT SAFEGUARDS Before the appliance is used, it must be properly positioned and installed as described in this manual, so please read the manual carefully. To reduce the risk of fire, electrical shock, or injury when using the appliance, follow basic precautions, including the following: • • • • • • • • • • • • • • Plug into a grounded 3-prong outlet, do not remove the grounding prong, do not use an adapter, and do not use an extension cord.
• • • • • • • • • • • • • Use two or more people to move and install the appliance. Failure to do so can result in back or other injury. To ensure proper ventilation for your appliance. The front of the unit must be completely unobstructed. Choose a well-ventilated area with temperature above 60°F (16°C) and below 90°F (32°C). This unit must be installed in an area protected from the elements, such as wind, rain, water spray, or drips.
LOCATION OF PARTS No. Part Name Description 1. Discharge Outlet Since cold air flows through this outlet into the refrigerator, be sure to avoid blocking it with stored food. 2. 3. 4. 5. Freezer Shelf Temperature Control Plastic coated Shelves Suction Inlet 6. 7. 8. 9. 10. 11. Interior Light Interior Light Switch Ice Cube Tray Panel Guard Glass Shelf Leveling leg Air that circulates throughout the refrigerator flows through this opening to regulate the temperature inside the refrigerator.
INSTALLING YOUR REFRIGERATOR • • This appliance is intended to be used in household or similar applications. To use your appliance with the most efficiency and safety, select a suitable place installation according to the following: 1. This appliance is designed for free-standing installation only, and should not be recessed or built-in. 2. The appliance should be installed on a strong level floor or counter. If the floor is not quite level, adjust the leveling feet. 3.
REVERSING THE DOOR SWING Refer to the disassembly diagram, and change the door hinges in the following procedure. The numbers in the diagram indicate the procedure order in the instructions. 1. Remove the hinge cap by twisting it off. 2. Remove the upper hexagonal head screws. The top hinge and the freezer door can now be removed. 3. Remove the middle hexagonal head screws. The middle hinge and the refrigerator door can now be removed. 4.
11. Attach the shaft to the hinge bottom. Attach the refrigerator door to the shaft. 12. Rotate the middle hinge 180o. Attach it to the refrigerator door and secure it with a screw. (Do not tighten the screws completely.) 13. Attach the upper hinge to the freezer door. Attach the freezer door to the middle hinge and use the screws to attach the upper hinge. (Do not tighten the screws completely.) 14.
REMOVING CUBES FROM THE ICE TRAY • • The ice cube tray is flexible. Twist the tray to remove ice cubes. Do not use boiling water or a metal instrument such as a knife or screw driver to remove ice cubes from the tray. This may damage plastic parts. CLEANING AND CARE • • • • • Turn off the refrigerator and remove foods, shelves, trays, etc. Wash the interior liner with a solution of warm water and two tablespoonfuls of baking soda per quart. Then rinse and wipe.
TROUBLESHOOTING You can solve many common freezer problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. PROBLEM POSSIBLE CAUSE The appliance does not operate. The unit is not plugged in The circuit breaker has tripped, or a fuse has blown. The appliance temperature control is set at "OFF". The appliance turns on and off frequently. The room temperature is warmer than normal.
NOTES 11
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this unit is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factoryspecified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for two years from manufacturing defects.
