User Manual

NOTE: For an activated high alarm and low alarm buzzer, the display should indicate HI-ALARM

and LO-ALARM (see illustration on previous page).

KEYPAD LOCK

A keypad lock is optional on most models. Use the instructions below to use your keypad lock.

Factory-set Default Password

The factory-set default password is 0123. If the default

password is lost, press the key (located

inside the battery box) for

30 seconds, then wait for the warning sound which signifies the factory-set

default password has been restored.

Setting the Password:

While door is open, press the key (located inside the battery box) until it jingles, enter the 0123

password, then # within 10 seconds to confirm. Enter your password (1-16 digits), then press #

again to confirm. A total of 10 passwords can be set.

NOTE: Each password starts with a number from 0 to 9 in order. The first password starting with 0 is

the default password. For example, use 1xxx, then 2xxx etc. for 10 users.

Changing the Password:

While the door is open, press the key (located inside the battery box) until it jingles, enter the old

password and press # within 10 seconds to confirm. Enter the new password, then press # to confirm.

The first digit cannot be changed.

To Open the Door:

While the door is closed, press the START/END key, enter the password, then press START/END

again to confirm.

To Lock the Door Manually:

Press #.

Function setting of automatic lock

Setting of the auto-lock time: Press the key (inside the battery box), enter a number (any number

between 10 and 99), then press # to confirm. The auto-lock time can be set between 10 and 99

seconds after opening the door. If the time is set less than 10 seconds, the door will not lock

automatically, only manually.

Deleting the door-opening passwords

Press the START/END key, enter default password followed by 0000, then press # and all the door-

opening passwords will be deleted except for the default password.

NOTE: To access the battery box you need to remove only the two small screws on the top and

bottom of that cover. Do not remove the 4 screws holding the keypad and cover to the

appliance door.