Use and Care Guide
  Felix Storch, Inc. 
 Page 12   SUMMIT PROFESSIONAL DIV. 
APPLIANCE OPERATION (by Model) 
FF6BI – FF7BI – SCR600LOS – SPR7OS – SPR601OS – SCR600BI – SWC6GBI – ALB751 – ALB753B Series  
DEFROST  SYSTEM,  OPERATION  AND  SHELF  ADJUSTMENT  – All models of the above series are all-refrigerators, 
with no freezer compartment and an auto-defrost system. During the compressor operation, ice will build up along the cold 
rear wall (the evaporator plate is behind the wall). During the compressor’s off-cycle, ice will melt, drip down, collect in the 
trough at the bottom and drain through the small hole into a tray above the compressor, where the compressor’s heat will 
evaporate the water. If you notice excessive ice build-up on the rear wall, try setting the thermostat to a slightly warmer 
setting; be sure that the gasket is sealing well and that there is no obstruction of the drain hole in the bottom rear of these 
units. Models with black cabinets include glass shelves. These shelves stop short an inch before the back wall, which is 
essential for air flow and the automatic defrost system. Do not block with food or containers. All models have removable, 
easily adjustable shelves. To remove a shelf, simply lift the rear of the shelf out of its locking position and slide the shelf 
forward. Replace shelves the same way, being sure they lock into place. The thermostat of these units is located at the 
top on the right hand side as you face the refrigerator. Turn clockwise for colder operation, and counter-clockwise to save 
energy  and  increase  the  temperature.  The  light  on  the  FF6BI  models  is  controlled  by  an  automatic  plunger  switch 
whenever the door is opened. Models with glass doors and flat door liners have a rocker switch to manually turn the light 
on or off. The light should be kept off when the door is closed to save energy and help keep interior temperatures lower. 
BI540 – BI541 – CT67BI – ALB651 – ALB653B – CT66BI – CT66B Series  
DEFROST  SYSTEM,  OPERATION  AND  SHELF  ADJUSTMENT – Models above are refrigerator-freezer combinations 
with a manual defrost freezer section and an automatic defrost fresh-food section. When ice builds to ½ inch around the 
freezer, empty the contents of the whole unit and defrost carefully (DO NOT USE SHARP OBJECTS) following directions 
earlier in this manual. The fresh food section will defrost itself, exactly like the models in the previous section. The freezer 
in this unit is rated four stars, which makes it suitable for ice-cream and short term storage of meats and other perishable 
items. For best storage, be sure not to over-pack and assure the freezer door closes fully. Shelves adjust the same as in 
the section above. Models with black cabinets as well as CT67BI models include glass shelves. These shelves stop short 
an inch before the back wall, which is essential for air flow and the automatic defrost system. Do not block with food or 
containers.  The  thermostat of these units  is located  at  the top on  the  right hand  side as  you face  the refrigerator.  Turn 
clockwise for colder operation, and counter-clockwise to save energy and increase the temperature. Lights on these units 
are all controlled by an automatic plunger-type switch.  
SCFF55 Series  
These units are frost-free freezers with a fan-cooled interior. The cooling is provided by the evaporator module mounted to 
the top of the unit. Air is circulated through the fan grill at the front of the unit and an outlet at the rear of the unit. Try to 
keep the air path as free as possible for optimal performance. Normally, no defrosting of these units is needed. There are 
no user serviceable parts within the evaporator module, so do not tamper with or attempt to move this part. It is part of the 
sealed refrigeration  system. Models with black cabinets include glass shelves. These shelves stop short an inch before 
the  back  wall,  which  is  essential  for  air  flow.  Do  not  block  with  food  or  containers.  All  models  have  removable,  easily 
adjustable shelves. To remove a shelf, simply lift the rear of the shelf out of its locking position and slide the shelf forward. 
Replace shelves the same way, being sure they lock into place. The light in the SCFF55 models is controlled by a manual 
rocker  switch.  Keep  the  light  off  when  the  door  is  closed  for  better  performance  and  to  save  energy.  Models  with  ice-
makers installed do not include an interior light.  
SWC6GBI Series Wine Cellars  
These wine cellars are fully automatic defrost (see description of the  defrost system under Model FF6BI series above). 
There is a light in the upper right corner, controlled by a rocker switch. Base models of the SWC6G series have chrome-
plated  shelves,  while  some  models  are  equipped  with  optional  flat  wire  shelves  or  wooden  shelves.  For  maximum 
capacity, it is possible to  lay wine  bottles at the rear of  the shelves cross-wise, behind the bottles facing forward. Keep 
one  inch  of  clearance  behind  the  shelves  and  the  rear  wall  for  air  circulation  and  the  efficient  operation  of  the  defrost 
system.  Glass  doors  should  be  cleaned  with  non-abrasive  glass  cleaners,  and  it  is  recommended  that  the  interiors  be 
cleaned with only a baking soda / water mix so odors are not left behind that can be absorbed by corks. These models are 
one temperature zone only, although the lower shelves are normally a few degrees colder than the upper shelves. 










