Instruction Manual

R3-081016 3
Configure parameters
Refer to the data management software instructions for details (pages 8 –14)
Default Settings
Other settings
Logging interval
5 minutes
0-11 hours; 0-59 minutes; 0-50 seconds
Stop mode:
Software
Manual stop (see pp. 3-4 )
Start Mode:
Instant on
Manual and timing start (pg. 3)
Temp. Unit
o
C
o
F
Buffer Ring:
Disabled
Enabled
Alarm
Settings
H1 (high alarm) =
10
o
C
User defined
L1 (low alarm) =
2
o
C
Alarm Mode:
Single
Cumulative
Start the data logger
There are three modes to start the logger – instant-on, manual start, and timing start.
1. Instant-on: After parameter configuration, the data logger starts recording
immediately when it is disconnected from the USB.
2. Manual start: After parameter configuration, press and hold the button for 5
seconds to start the data logger. In this mode, it has a start delay function. If this
function is enabled, the data logger will not record data immediately after start-up
but start recording after the set delay time elapses.
3. Timing start: After parameter configuration and disconnection from USB, the data
logger starts recording when it reaches the set time.
View data instantly
If you need to view simple statistical information, you may directly press the button to turn
the page and check. The LCD screen can display MKT, average value, Max value and Min
value. Mean Kinetic Temperature (MKT) is a simplified way of expressing the overall effect
of temperature fluctuations during storage or shipment of perishable goods.
If you need detailed information, please connect the data logger to the computer’s USB.
After about 3 minutes, the data will be saved. You can open it as an Excel, AI or PDF
report.
Moreover, you can connect the data logger to a computer and analyze the data using the
data management software.
Stop the data logger
There are several modes to stop it – manual stop, stop via software, over-Max-
record-capacity stop (enable/disable manual stop).
1. Manual stop: When the data logger is recording in this mode, you may press and hold
the button for 5 seconds to stop it.
2. Stop via software: You can stop the data logger via software
by
selecting the Stop recording option on the software platform.
If the record capacity reaches the Max value (32,000 points)
Caution!
Make sure you have saved selected parameters.