Manualshelf

Instruction Manual

ManualsBrandsAccuCold ManualsCompact Refrigerators24 Inch Compact Refrigerator with 5.1 Cu. Ft. Capacity, Adjustable Glass Shelves, Manual Defrost Freezer, Door Storage, Fruit/Vegetable Crisper, Door Lock, and ADA Compliant: Stainless Door with Horizontal Thin Handle
12345678910
6
To prevent accidental injury, the cord should be secured behind the unit and not left exposed or
dangling.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheated wires.
Never unplug the unit by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately any power cord that has become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the unit, be careful not to damage the power cord.
Extension Cord
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Reversing the Door Swing (not applicable to units with the suffix TB, HV, IF or
CSS)
If you find the direction of opening the door of the appliance inconvenient, you can change it. Holes
on the opposite side have already been prepared at the factory.
This appliance can be opened from either the right side or the left. By default, the door hinge is on
the right side. If you prefer it on the left, please follow the appropriate instructions:
For models CT66W and CT66BK:
1. Take off the upper hinge cover from the door and remove the screws that hold the top hinge.
2. Lift the hinge straight up to free the hinge pin from the socket in the top of the door.
3. Lift the door up and away to free its bottom socket from the hinge pin.
4. Remove the screws to the bottom hinge.
5. Remove the decorative caps from the opposite side and plug the holes from the original side with
the decorative caps.
6. Move the bottom hinge to the opposite side and tighten the screws. Use any lock washers or nuts
if they were installed in the original installation.
7. Replace door onto the hinge pin on the bottom hinge. Place top hinge pin into door. Insert screws
into the top hinge and tighten.
If you notice the door not hanging straight, loosen the top hinge screws, adjust the door until it is
level and tighten the screws.
NOTE: Shelves are adjustable. Models with black cabinets such as CT66BK include glass shelves.
These shelves stop short an inch before the back wall, which is essential for air flow and the
proper operation of the automatic defrost system. Do not block these gaps.