Instruction Manual

AccuCold, Div of Felix Storch, Inc. | R005-07102018
8
Troubleshooting
Displays „NP‟
 The temperature sensor is not installed correctly.
Display screen not working
 Make sure the AC adapter and batteries are installed correctly.
“Low battery” indicator
flashing
 Battery may need to be recharged.
Logger is not logging
 Press the key and make sure the REC symbol appears on the
display.
 The logger will stop logging if AC power is removed and rechargeable
battery is not connected or not charged.
Logger is taking too long to
copy data to a flash drive
 The logger internal memory should be cleared
The date sequence of the
logged data is NOT
accurate
 Reset the date and time on the logger
Recorded data is corrupted
 Make sure the unit is not installed in an area with strong electromagnetic
interference.
The logger does not record
data when the AC power is
OFF
 Is the rechargeable battery inserted correctly? Please note the negative and
positive poles of the battery during replacing a new battery.
 The rechargeable battery has not been charged prior to the power failure.
The battery needs to be charged for a minimum of 2 days.
Recalibration
It is recommended that Felix Storch, Inc., temperature monitoring products be calibrated every two years to ensure
proper function and accurate measurements; however, your quality system or regulatory body may require more
frequent calibrations. To schedule your recalibration, please contact our ISO/IEC 17025:2005 calibration laboratory
accredited by Perry Johnson Laboratory Accreditation, Inc., at [e-mail]
Care & Maintenance
 Do not disassemble the product, as product damage may result.
 Store the product where it will not be exposed to direct sunlight, dust or high humidity.
 Do not wash or expose the product to water or other liquids.
 Clean the product by wiping with a soft, dry cloth.
 Never use volatile or abrasive liquids or cleaners to clean the product.
 Do not drop the product or subject it to sudden shock or impact.
 The sensor cable leads must be kept away from main voltage wires in order to avoid high frequency
noise. Separate the power supply of the loads from the power supply of the Logger.
 When installing the sensor, place it with the head upward and the wire downward.
 The logger must not be installed in an area where water drops may be present.
 The logger must not be installed in an area where corrosive materials or a strong electromagnetic
interference may be present.