Instruction Manual

7
Installing the Handle
This appliance includes a handle that is not required to operate the unit. To install the handle, follow
the instructions below:
1. Use a screwdriver to remove the screws on the side of door where the handle is to be installed.
2. Align the handle with the screws removed in step # 1. Tighten the screws using a Phillips head
screwdriver until the handle is both flush and secured tightly against the door side. (DO NOT
over-tighten as this will cause damage to the door surface.)
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 44º
and 90ºF (7º to 32ºC). If the ambient temperature is above or below the recommended temperatures,
the performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The operating temperature range may not be
reached.
NOTE: If the door of the unit is left open for more than 60 seconds, an alarm will sound. The alarm
will stop once the door is closed.
Control Panel for Digital Thermostats
Refrigerators and freezers include a digital thermostat located in the kick plate of your unit.
Indicator Symbol Table:
Indicator
Symbol
Status
Meaning
Setting
Set
ON
Set parameters
OFF
Temperature measuring and controlling
Cooling
ON
Cooling active
OFF
Cooling inactive
Flash
Cooling delays
Defrost
ON
Defrost active
OFF
Defrost inactive
Dripping
drip
ON
Dripping active
OFF
Dripping inactive
Measurement unit
indicator light
℃
ON
Unit of measurement display
Measurement unit
indicator light
℉
ON
Unit of measurement display