User Manual

INSTALLING THE HANDLE

This appliance includes a handle that is not required to operate the unit.

To install the handle, follow the instructions below:

1. Use a screwdriver to remove the screws on the side of door where the

handle is to be installed.

2. Align the handle with the screws removed in step # 1. Tighten the

screws using a Phillips head screwdriver until the handle is both flush

and secured tightly against the door side. (DO NOT over-tighten as

this will cause damage to the door surface.)

OPERATING YOUR APPLIANCE

It is recommended you install the appliance in a place where the ambient temperature is between 72º and

78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the

performance of the unit may be affected. For example, placing your unit in extremely cold or hot

conditions may cause interior temperatures to fluctuate. The operating temperature range may not be

reached.

CONTROL PANEL FOR ACR45L THERMOSTAT

ON/OFF Power

To turn the appliance ON or OFF, press the symbol and hold for 5 seconds.

NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on.

Used to increase (warm) the set temperature by 1°C/1ºF.

DOWN

Used to decrease (cool) the set temperature by 1°C/1ºF.

ºF/ºCSelector

Select the temperature display in Fahrenheit or Celsius degrees. To change the temperature from

Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5 seconds.