Datasheet

6
7
Anti-Vibration
capability
1) According to standard capacity
charging the battery fully
2) Fully charged Battery or Battery Pack
then fixed on the vibration table, use a
sine wave vibration and use logarithmic
sweep mode within 15min from 7Hz
sweep to 200Hz then return to 7Hz,
vibration based on samples three vertical
direction and every direction need
repeated 12 times, total shake 3H
There should be no obvious crack,
leakage, smoking or exploring on the
appearance of the
8
Drop test
1) According to standard capacity
charging the battery fully
2) Put the battery at a height of
1.1-1.3 meter, drop the cells on
six sides freely
There should not be leakage, smoking
and exploring
9
Constant damp
heat test y
1) According to standard capacity
charging the battery fully
2) Put battery and battery pack into 40℃
± 2 ℃ and relative humidity 90% ～
95% constant temperature and humidity
chamber set for 48h then remove battery
into 23℃±2℃ environment set for 2H,
check battery or battery pack appearance
and use 0.2ltA current discharging to cut-
off voltage
There should be no obvious crack,
leakage, smoking or exploring on the
appearance of the