Manual

UNLOADING:
Slide the safety lever to the “ON” position ( white dot ) and remove the magazine by
pushing the magazine catch rearward and pulling the magazine down and out of the
frame. Keeping the pistol pointed in a safe direction, pull the slide back fully to eject the
cartridge from the chamber. Holding the slide back, look in the chamber to ensure the
pistol is empty. To de-cock your pistol, the hammer must be grasped and lowered
carefully as the trigger is pulled.
DISASSEMBLY:
WARNING!
ALWAYS CHECK TO MAKE SURE YOUR PISTOL IS UNLOADED BEFORE
YOU BEGIN TO DISASSEMBLE!
Remove the trigger guard screw, then remove the trigger guard, fully retract the slide, lift
up and forward off the frame. Do not allow the hammer to drop forward when the slide is
removed, as this may cause damage to internal parts. We suggest that you do not take
down this firearm any further than is explained in this manual.
REASSEMBLY:
WARNING!
Excel Industries, Inc. assumes no liability or responsibility whatsoever for injury, death,
or damage to property resulting from incorrect reassembly, removal or altering of any
parts in any manner.
With the hammer cocked, replace the slide on the barrel, pull it back fully and push it
down on the frame and into the guide rails, then allow the slide to move forward into
position. Now replace the trigger guard and secure the trigger guard screw making
certain screw is fully seated before firing.
CARE AND CLEANING:
After disassembling the barrel and chamber should be cleaned with a bore solvent, using
a brush if needed. Wipe dry and oil lightly. Use a solvent on cotton swabs or a patch to
clean all exposed internal surfaces.
Lubricate all moving parts with a light high quality gun oil. Be sure to lubricate the
contact points between the slide and frame, and a few drops on the hammer strut spring.
Wipe off any excess oil.
WARNING!
Avoid use of solvents on grips or prolonged use on sights as it may cause damage.