Manual

SAFETY:
The safety is located on the left side of the slide. By pushing the safety lever down as far
as possible so that the white dot is exposed, thus indicating the “ON” position. This
blocks the firing pin from the hammer and disconnects the trigger. By pushing the safety
lever upward exposing the red dot indicates the “OFF” firing position.
WARNING!
THIS FIREARM IS CAPABLE OF FIRING WITH THE MAGAZINE
REMOVED!
WARNING!
This Pistol incorporates a well-designed safety device; however never rely completely on
any safety mechanism. All mechanical devices are subject to breakage, wear or incorrect
maintenance and should never be trusted.
AMMUNITION:
This pistol was designed to use standard “BALL NOSE” full metal jacketed bullets. Use
only new commercially manufactured ammunition and only of the caliber for which your
firearm is chambered. Selected ammunition should be test fired at least 100 rounds to
ensure reliability. Ammunition manufacturers can make changes to their ammunition
either dimensional, a different powder or primer. These changes could cause a previously
reliable ammunition to cause malfunctions. One of the keys to a reliable firearm is
consistent ammunition.
WARNING!
The use of non-standard, reloaded or hand loaded ammunition voids all warranties. The
use of such ammunition can cause damage to the firearm and serious injury to the shooter
or to others.
LOADING:
To load the magazine push down the front of the follower with the rim of the cartridge,
then slide the round back under the magazine lips. Repeat until the magazine is loaded
with up to 6 rounds.
To unload the magazine, push each cartridge forward until it is no longer held by the
magazine lips.
Load your firearm by keeping your finger off the trigger and the safety “ON”! Insert the
magazine in the pistol by pushing it upward into the magazine well until it is retained by
the magazine catch. Grip the pistol with your shooting hand, keeping the muzzle pointed
in a safe direction. With your other hand, grasp the serrated surfaces at the rear of the
slide and pull fully to the rear then release it promptly allowing it to return on its own.
This action will chamber the first cartridge, cock the hammer and the pistol is ready for
firing. ( If the slide is too difficult to pull back, cock the hammer first. This will enable
the slide to be pulled back with less spring pressure. )