Service manual

SP8016-1005 ACCU-STEAM SERVICE MANUAL PAGE 9
HI-LIMIT ASSEMBLY
Is a safety designed to turn off the griddle at a preset temperature to limit the pressure of the
steam chamber so that it doesn’t set off the one time pressure relief valve which will render
the griddle un-repairable
1.
2. Verify the Hi Limit rod has
pulled and released the switch before proceeding.
3.

Note: The entire assembly will want to drop down when removing the bracket.
4.

Note: It is extremely important that the solder washer has good surface contact with the
surface of the thermal-well. Make sure the solder washer is installed before the at washer.
5. See the drawing on the following page.
TIME DELAY RELAY
The time delay relay is used to delay a signal to allow for the proper mixture of air and gas
before igniting the main burners.
1.
2.
3.
4.
Note: Make sure the adjustment pot is set for 20 seconds.

AT2H-2500
TIME DELAY ADJUSTMENT
SET FOR 20 SECONDS
SOLDER WASHER
AT2M-2860-1
WASHER
AT2F-1367-1
ROD
AT2M-2861-1
MICROSWITCH
COVER
AT2E-1759
COMPRESSION
SPRING
AT2H-1365-1
EXTENSION
SPRING
AT2H-1640-1

AT2M-1558
MICROSWITCH
AT2E-1639-1
REMOVAL AND INSTALLATION