Operation Manual

2
21
Use the battery key to fully tighten the
battery cover. You can verify that the
battery cover is correctly tightened by
checking that it is in line with the pump
casing. Do not over-tighten.
Place the cover on the positive end and
gently push the battery in, while turning
the cover clockwise to partially tighten it.
After inserting the battery, the pump begins its start-up process
(see section below).
If the pump does not begin the start-up process after inserting
the battery, make sure that the battery is inserted correctly
(negative end first).
c CAUTION
If your pump reverts to the factory settings for the date and
time immediately after the power supply is interrupted for a
short amount of time, please contact your customer support
to report this issue as it may be due to a component failure.
5.
6.
man_05504929001_H_en-us.indb 21 01.06.2016 08:14:33