Operation Manual

139

7.2 Damage to your pump

7.2.1 What to do if you drop your pump

If the pump is dropped it could be damaged, as well as the seal

that protects it against water. Use the specially designed pump

carrying system to help avoid dropping your pump. See Roche

Diabetes Care, Inc. sterile products and accessories catalogs and

brochures for more information, or contact your Accu-Chek

Customer Care (details on inside back cover).

If you drop your pump:

j Check that all the connections of your infusion set are still

tight, and if they are not, reconnect or tighten them

j Check your pump, its sterile products, and accessories for

chips and cracks

j Change the cartridge if it is damaged

Put your pump in STOP mode, disconnect the infusion set, and

take out and reinsert the battery, so that the self-test is started

then put your pump back in RUN mode.

Note If a Temporary Basal Rate, an Extended Bolus or a

Multiwave Bolus is active at the same time, it is cancelled

when your pump is put into STOP mode. The warning W8:

BOLUS CANCELLED or the warning W6: TBR CANCELLED

is displayed.

Press f twice to confirm and turn off the alert. The

alerts are recorded in the alarm history.

See chapter 8 Warning W6: TBR CANCELLED and Warning

W8: BOLUS CANCELLED.

Make sure that the cancellation was deliberate, put your

pump back in RUN mode, and then program a new

Temporary Basal Rate (and / or an Extended or Multiwave

Bolus), if needed.

man_05504929001_H_en-us.indb 139 01.06.2016 08:14:51