Operation Manual

23
Meter Memory, Setup, and Data Transfer
3
Press and release to
turn the meter on.
The flashing test strip
symbol appears on the
display.
Press and hold
until
set‑up appears on the
display.
1 2
Press and release
repeatedly until the bell
symbol, OFF, set‑up, and
the flashing A‑1 appear
on the display.
Press and release
or to switch
between On and OFF.
Press and release
to
set your choice.
If On is selected, the hour
flashes.
3
Press and release
or to adjust the
hour.
Press and release
to
set the hour.
The minutes flash.
4
Test reminders:
• beep at the same time each day.
• beep every 2minutes up to 3times.
• turn o by inserting a test strip or pressing
any button.
• If a test was performed within 15minutes
of a test reminder, the test reminder does
not beep.
• If the meter is on at the test reminder time,
the test reminder does not beep.
• Exposure to cold conditions may disable test
reminders until the meter is turned on.
• If a test reminder is o in set‑up mode, any
subsequent test reminders are also o. For
example, if you set A‑1 but turn o A‑2, then
A‑3 and A‑4 will automatically be o.
Setup
Setting the Test Reminders
NOTE
52955_07054190001_02_EN.indb 23 12/8/14 2:02 PM