Operation Manual

5
30
Meter Memory, Setup, and Data Transfer
Press and release or
to switch between am
and pm.
Press and release
to set
am or pm.
5
The bell symbol, OFF, and
the flashing A-2 appear
on the display.
Either set the A-2 test
reminder or press and
release
to set up more
options.
6
Turn the meter on.
The flashing test strip
symbol appears on the
display.
Press and hold
until
set-up appears on the
display.
1
2
Press and release
repeatedly until the bell
symbol, OFF, set-up, and
the flashing A-1 appear.
Press and release or
to switch between On
and OFF.
Press and release
to set
your choice.
If On is selected, the hour
flashes.
Press and release
or
to adjust the hour.
Press and release
to set
the hour.
3
The minutes flash.
Press and release
or
to select 00, 15, 30, or
45. These are the only
choices.
Press and release
to set
the minutes.
Am or pm flashes on the
display.
4
NOTE
Test reminders:
• beep at the same time each day.
• beep every 2 minutes up to 3 times.
• turn o by inserting a test strip or pressing any
button.
• If a test was performed within 15 minutes of a test
reminder, the test reminder does not beep.
• If the meter is on at the test reminder time, the test
reminder does not beep.
• Exposure to cold conditions may disable test
reminders until the meter is turned on.
Setting the Test Reminders
7
To exit, press and hold
until the flashing test strip
symbol appears on the
display.
51742_06333630003.indb 30 1/22/13 1:17 PM