Operation Manual

93
8
Acoustic mode
If you directly retrieve stored test results using the button , you will first hear the power-on beep and
immediately afterwards the test result:
test result test result test result.
If XX.X is displayed as the last (most recent) test result, the last test did not deliver a test result (see
page66). In this case, the beep tones issued are identical to those for an error message.
Flags are not announced acoustically (for example,
Before meal).
There is no acoustic announcement if the last saved result is a control test flagged with
, if there are
no stored results or if you retrieve an average.
Announcing warnings and error messages
When battery power is low or the test cassette has been used up, the meter issues an acoustic warning.
This consists of 2 short beep tones (
) sounded three times in succession ( ).
The warning is given at dierent times.
• Batteries almost empty:
The acoustic warning sounds after you have turned the meter on, together with the corresponding
message on the screen (see Changing the batteries page114).
• Test cassette empty:
The acoustic warning sounds when the number of available tests is displayed as zero when turning the
meter o.
If error messages appear on the screen (see Error messages page124), these are announced by
2 short beep tones (
) sounded four times in succession ( ). This sequence is sounded
only once and is not repeated. The same sequence of beep tones is sounded for all error messages, i.e.
they are not dierentiated acoustically.
man_07438877001_01_EN.indb 93 11.05.2015 14:07:58