Operation Manual

씰 If you performed the test with Accu-Chek Active Control 1,
refer to row 1 for the permitted range.
씰 If you performed the test with Accu-Chek Active Control 2,
refer to row 2 for the permitted range.
If the result is within the stated range, you need to still carry out a
visual plausibility test. It is important that this check be performed
within 30–60 seconds after control solution was applied. Any later
than this and comparison is no longer possible owing to excessive
discolouration of the test strip.
If the result is outside the stated range, perform a second quality
control test. If the second result is still outside the range, please call
your customer support and service centre.
씰 Pull the strip out of the meter. The result is saved as a control
reading (which is ignored when the averages are calculated),
and the meter switches off.
93
man_04493168001_02_EnUK.indd 93 1/12/2006, 11:29:15 ðì