User`s manual

175
For sighted persons: Using the meter and cleaning the devices
5
When the test strip has drawn up sufficient blood, the meter beeps (provided the beep tone is turned on), the test strip symbol
disappears and the blood drop symbol stops flashing. Measurement starts automatically and 000 appears in the display.
 Move your finger away from the test strip.
Measurement takes approximately 5 seconds. As the meter conducts the test,
the three 000 disappear in turn from the display.
If the test does not start, you applied too little blood. You can then apply more blood within 25 seconds.
 After you have applied blood to the test strip, wipe the puncture site with a dry, clean tissue and keep it clean.
On completion of the test, the result appears in the display. The meter automatically saves
the result to memory.
i
If you hear beep tones when the test result is displayed, the Acoustic Mode has
been turned on in your meter.
You can turn off the Acoustic Mode and with it the beep tones (see Chapter 16.1).
AC_Voicemate_Manual_EN-CAN.indd 175AC_Voicemate_Manual_EN-CAN.indd 175 1.5.2007 13:17:181.5.2007 13:17:18