User`s manual
102
More functions of the voice unit and user guidance
F
a
r
be
: P 2
8
1 – Pr
ü
fmi
tte
ln
u
mm
e
r: 2
05
3
If you wish to have the data sets next to a hit read aloud, press the Up button briefly for the older data sets and the Down
button briefly for the newer data sets. If a neighbouring data set is also a hit, the announcement is again introduced by
the beep tone.
Next, the date, time and result saved in the data set are read aloud. Using the Right and Left buttons, you can summon
the other entries in hits and adjacent data sets. You may change any entry except the date, the time and the result (see
Chapter 12.5).
12.3.4.2 Change search criteria and search (2-2-2)
For all entries other than events you can enter as search criterion a lower value or an upper value, or a lower and an upper
value.
The voice unit makes a suggestion for each search criterion. This suggestion is either the search criterion you entered
earlier, or you hear “No entry”, because you have not yet entered a search criterion. If you wish to accept the suggestion,
press the OK button. If you wish to change the search criterion, enter the desired value and press OK to confirm.
You do not have to enter search criteria for all entries. When you have entered your search criteria, you can start the
search from any location. Press the Down button and then OK.
From the last possible search criterion, the second event, you need only to press OK or the Right button.
The most recent data set that matches all of the search criteria is then read aloud together with the date, time and result.
AC_Voicemate_Manual_EN-CAN.indd 102AC_Voicemate_Manual_EN-CAN.indd 102 1.5.2007 13:16:341.5.2007 13:16:34