Operation Manual

Preparing the ACCU-CHEK® Voicemate Plus for Communication

Before attempting to connect the

for communication with the

follow these recommendations:

●

Check the USB connection. Make sure the infrared cable is securely inserted into a USB port on your

computer.

●

Use only an approved infrared cable. Built

in infrared windows in portable computers are not currently

supported.

●

Relocate any devices near the infrared cable that may interfere with its proper function, such as keyboards,

mice, personal data assistants (PDAs), and notebook computers with infrared windows.

●

Avoid direct sun exposure to the infrared cable and the infrared window of the

●

Make sure that only the device used for the communication is within receiving range of the infrared cable.

Prepare the

health management device for communication by using the following

steps:

Set the

on a flat surface and point the top of the

toward the front of the infrared cable. The

should be about 10 cm (4 inches)

from the infrared cable.

Show me how to put my health management device in communication mode.

With your

turned on, press 0, then press 3 and then press 3 again. You hear

spoken prompts after each selection. This puts the

in communication mode.

You are now ready to use the

software to communicate information from the

. Do not move the

or the cable while the devices

are communicating.

ACCU

CHEK, ACCU

CHEK 360°, and VOICEMATE are trademarks of Roche.

All other product names are property of their respective owners.

Download

( v1.4 )

Preparing the ACCU

-CHEK®

Voicemate Plus for Communication

Version: 1.2