Operation Manual

Putting the ACCU-CHEK® Spirit Combo Insulin Pump in

Communication Mode

The built

in infrared interface on the bottom of the

insulin pump enables the user to

transfer data between the insulin pump and the computer.

To prepare the

insulin pump for communication:

Put the

insulin pump in

STOP mode.

Press

to move to the

Data Transfer

screen shown on the insulin pump's display. Press

to select.

Press

Show me how to put the insulin pump in communication mode.

Set the

insulin pump on a flat surface.

Point the bottom of the insulin pump toward the front of the supported infrared cable. The insulin pump

should be approximately 4 inches (10 cm) from the infrared cable. Do not move the insulin pump or the

cable during the communication between the insulin pump and the computer. The

software is now ready to communicate information from the insulin pump.

When the data transfer is complete press

to return to the

STOP mode.

Note:

The insulin pump automatically returns to the

STOP

mode 15 minutes after the last data transfer when the

Data Transfer screen in selected.

Press

and

twice simultaneously to exit while data is being transferred. The data transfer is interrupted,

and an error message occurs.

Download

( v1.4 )

Putting the ACCU

-CHEK®

Spirit Combo Insulin Pump in Communication Mode

Version: 1.2