Operation Manual

Preparing the ACCU-CHEK® Mobile Meter for Communication

The process for preparing the

meter for communication varies depending on which model you

are using.

Follow these instructions for this meter:

Show me how to put my meter in communication mode.

Before attempting to connect the

meter for communication with the

, follow

these recommendations:

●

Check the USB connection. Make sure the infrared cable is securely inserted into a USB port on your

computer.

●

Use only an approved infrared cable. Built

in infrared windows in portable computers are not supported.

●

Relocate any devices near the infrared cable that may interfere with its proper function, such as keyboards,

mice, PDAs, and notebook computers with infrared windows.

●

Avoid direct sun exposure to the infrared cable and the infrared window of the meter.

●

Make sure that only the device used for the communication is within receiving range of the infrared cable.

Prepare the

meter for communication by using the following steps:

If the meter is on, turn it off.

With the meter off, press and hold the two

arrow

buttons on the meter at the same time until the meter turns

on.

Select For Analysis

. Doing so puts the

meter in communication mode.

Set the

meter on a flat surface and point the top of the meter toward the front of the

infrared cable. The meter should be about 10 cm (4 inches) from the infrared cable. Do not move the meter

or the cable while the devices are communicating. You are now ready to use the

software to communicate information from the meter.

Follow these instructions for this meter:

Download

( v1.4 )

Preparing the ACCU

-CHEK®

Mobile Meter for Communication

Version: 1.4