Installation Guide

ManualsBrandsAccton Technology ManualsElectronicsUpgrade Kit - 802.11g

1

2

3

4

5

6

7

8

Table Of Contents

Kit Contents
- 1 Align the antenna module with the snaps and posts on the unit and press until the module snaps ...
  - 2 Align the free end of one cable with one connector on the board. Press until the cable snaps in...
  - 3 After the cables are connected, press them down out of the way inside the housing.
Regulatory Compliance Information

2 Remove the back cover.

Using a cross-tip screwdriver, remove the four screws from the back cover. Remove the cover from the unit. Set

the cover and screws aside.