User's Manual

BETA DRAFT
Altitude 300-2 Getting Started Guide 13
Mounting On A Wall
The Altitude 300-2
™
can be mounted on a vertical surface using the universal mounting bracket
supplied. The vertical position should be with the Ethernet cable and lock hasp pointing up. Select the
location for the unit and use the bracket as a template to mark the holes in the ceiling. For each of the
four plastic anchors supplied with the unit, drill 4.8 mm (3/16”} pilot holes, 24.5 mm (1”) deep. If wall
anchors are not being used drill 3.2 mm (1/8”) holes, 1 inch (25.4 mm) deep. Install the bracket using
the screws from the kit. The Altitude 300-2
™
is designed to slip into the mounting slots on the bracket
and slide all the way down, see Figure 5: Mounting The Wireless Port On The Universal Mounting
Bracket on page 14. The unit should then be secured with either a padlock or a cable tie. The installer
may now follow the standard instructions for connecting the Ethernet cable, antenna shrouds for
integrated antennas, and the plastic cover.
The Altitude 300-2
™
is not secured to the bracket unless a padlock is used. If a padlock is not used the
unit should be secured to the bracket by a cable tie through the lock hasp to keep it from falling. Failure
to secure the unit is hazardous.
Mounting On A Table Or Shelf
The Altitude 300-2
™
can be installed on a table or shelf using the stick-on feet supplied in the unit's kit.
After the feet are applied, the unit is placed on the horizontal surface and the powered Ethernet cable
attached. If the unit is to be locked a standard computer cable and lock can be used. The computer lock
hole is located at the rear of the Altitude 300-2
™
, see Figure 1: Rear View Of Altitude 300-2i
™
on page 7.
The antennas are installed and the antennas are adjusted now for optimal performance. After that the
plastic cover is attached, securing the antennas and Ethernet cable.