User Manual
Table Of Contents
- Using the Nortel Networks Wireless LAN Access Point 2220/2221-802.11b-only
- This multi-product manual describes some features not available on the 2221-802.11b-only Access P...
- Preface
- Hardware Installation
- Network Configuration and Planning
- System Configuration
- Specifications
- Template for placing the Access Point 2220/2221
- Mounting the Access Point 2220/2221 on a Drop Ceiling
Chapter 3 System Configuration 35
Using the Nortel Networks Wireless LAN Access Point 2220/2221
TCP / IP Settings
Figure 12 TCP/IP Settings screen
DHCP Client: With DHCP (Dynamic Host Configuration Protocol) Client
enabled, the IP address, subnet mask and default gateway can be dynamically
assigned to the access point by the network DHCP server. (Default: Enable)
If DHCP Client is not enabled, you must enter the IP address, subnet mask,
default gateway, and one or more DNS (Domain Name Servers) addresses. Enter
those addresses on this screen (Figure 12).
Note: You must disable DHCP for the manual TCP/IP addresses to be
accepted (Figure 12).
Note: If there is no DHCP server on your network, then the access point
will automatically start up with its default IP address, 192.168.168.10.