User Manual
Table Of Contents
- Using the Nortel Networks Wireless LAN Access Point 2220/2221-802.11b-only
- This multi-product manual describes some features not available on the 2221-802.11b-only Access P...
- Preface
- Hardware Installation
- Network Configuration and Planning
- System Configuration
- Specifications
- Template for placing the Access Point 2220/2221
- Mounting the Access Point 2220/2221 on a Drop Ceiling
20 Chapter 1 Hardware Installation
214853-B
Figure 2 Rear Panel
2 Connect the Console Port – Connect the console cable to the RS-232 console
port for accessing the command-line interface. (Refer to “Run Time Console
Specifications” for complete information on the CLI.) You can manage the
access point through this console connection, or the Web management
interface (refer to “System Configuration” on page 24.)
3 Connect the Ethernet Cable – The Access Point 2220/2221 can be connected
to a wireline network via a 10 or 100 Mbps Ethernet connection. Connect a
Cat 5 (or higher) UTP cable between the Access Point 2220/2221 and another
network device such as a hub or switch.
4 If you are not using PoE, use the separately orderable power adapter –
Connect the power adapter cable to the 5 VDC power socket on the rear panel.
Warning: Use ONLY the power adapter supplied by Nortel Networks for
this product. Otherwise, the product may be damaged. Contact your
Nortel Networks representative to order the power adapter.
5 V DC
Power Socket
RJ-45
Connector
(PoE)
Console
Port