System information

Command Line Interface
4-86
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enter interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Value: 1)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-86
description Adds a description to an interface configuration IC 4-87
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-87
negotiation Enables autonegotiation of a given interface IC 4-88
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-89
flowcontrol Enables flow control on a given interface IC 4-90
combo-forced-mode Force port type selected for combination ports IC 4-91
shutdown Disables an interface IC 4-91
switchport broadcast
packet-rate
Configures the broadcast storm control threshold IC 4-91
clear counters Clears statistics on an interface PE 4-92
show interfaces status Displays status for the specified interface NE, PE 4-93
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-94
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-95