Installation guide

Powering On the CPE

4. Connect one end of the cable to the RJ-45 port of the computer’s network

interface card, and the other end to the UTP port on the CPE. When inserting an

RJ-45 plug, be sure the tab on the plug clicks into position to ensure that it is

properly seated.

Notes: 1. Make sure each twisted-pair cable does not exceed 100 meters (328 feet).

2. We advise using Category 5 cable for all network connections to avoid any

confusion or inconvenience in the future when you upgrade devices to Fast

Ethernet.

Powering On the CPE

Plug the AC power adapter directly into a power outlet. Check the LED marked

“Power” on the front panel to be sure it is on.