User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Initial Configuration
4-8
3. IP Configuration – Either enable or disable (Dynamic Host
Configuration Protocol (DHCP) for automatic IP configuration.
If you disable DHCP, then manually enter the IP address and
subnet mask. If a management station exists on another
network segment, then you must enter the IP address for a
gateway that can route traffic between these segments. Then
enter the IP address for the primary and secondary Domain
Name Servers (DNS) servers to be used for host-name to IP
address resolution.
DHCP Client – With DHCP Client enabled, the IP address,
subnet mask and default gateway can be dynamically
assigned to the access point by the network DHCP server.
(Default: Disable)
Note: If there is no DHCP server on your network, then the access
point will automatically start up with its default IP address,
192.168.2.2.